Amana Oven Parts
View Amana Oven Replacement Parts Category
Part Number – WPW10308477
This bake element is located inside the bottom part of an electric oven and used for baking with. The bake element has (2) flat push-on terminals. Some common symptoms of a bad baking element are, the element will not heat, trips the circuit breakers when turned on, blows a fuse. Remember to disconnect the electrical power source to the oven before attempting to repair it. Turn the breaker dedicated to the unit off or pull the fuses. Note: Please be sure that your oven has had plenty of time to cool down before removing or testing any internal or external parts. Some range, stove and oven elements can retain residual heat for quite some time after they have been turned off.
Part Number – WPW10181986
This oven sensor works in conjunction with the oven main control board to regulate and measure the temperature in the oven. If you have noticed the oven temperature is inaccurate or fluctuates by 50 degrees or more, the sensor is more than likely defective and will need to be replaced with a new part. Please be sure to use your model number when searching for parts, to be sure that it is the correct part for your particular oven.
Part Number – WP8054129
This part is used to ignite the ovens gas burner with its spark electrode. It is the ignition device for the bake or broil setting on some gas model ovens. The common symptom of a bad igniter is, the gas burner will not light. Please remember to disconnect your appliance from its electrical power source and turn off the gas before attempting to repair it.
Part Number – WP3196548
This thermal fuse is used as a safety device in case the oven should overheat. This fuse will shut the oven off to prevent a fire. Please remember to unplug or disconnect the electricity to your appliance before making this repair.
Part Number – W10856603
This genuine OEM broil element is located on the top of the oven cavity and used for broiling with. The broil element is often used to help preheat the oven faster for baking. If the element is bad you should be able to see some visual damage, such as, blistering, bubbles, burned marks, burnt or melted terminal ends. You can test the element for continuity with an OHM meter. Always unplug or disconnect the electrical power source to your appliance before troubleshooting or attempting the removal or replacement of any parts.
Part Number – WP660533
This surface coil burner is used on the cooktop surface of an electric oven. The surface burner is 2600 watts and measures 8 inches in diameter. It has a five turn coil with rolled terminal ends. If your surface element is not heating you can test the part for continuity with a multi-meter. If the element has continuity you will need to test the surface element switch and the element terminal. Note: keep in mind that a surface burner can burn your hands, just because the burner is not glowing red, does not mean that it is not hot and cannot still burn you. Please wear safety gloves when removing or troubleshooting any oven heating elements. Think safety first!
Part Number – WPW10293048
This gas valve is used on a gas oven to sense a desired amount of heat.
Once it has sensed the desired amount of heat it will open the valve to
let the gas flow to the oven burner where it will then be ignited into
flame and used to heat the oven. Always unplug or disconnect the
electrical power source to the unit before attempting to repair it.
Part Number – WPW10345407
This heating element measures 6″ and is used on the surface of the oven for cooking. It is a three turn coil element with rolled terminal ends to push in or pull out of the oven receptacle. Always unplug or disconnect the electrical power source to the oven before attempting to repair or replace any parts. Please be sure and use your model number on your appliance to ensure that this is the correct part for your particular oven.
Part Number – WP660532
This OEM replacement surface coil element is used for an electric oven on the cooktop surface. The surface element measures 6″ in diameter with rolled terminal ends. If the element is not heating it can be tested for continuity using a multi-meter. If the surface element has continuity the part is good and you will need to test the element terminal and the surface element switch. Always disconnect the electrical power source to the appliance before attempting to remove or replace any parts.
Part Number – 72017
This touch-up paint can be used on the exterior of your white oven. If your oven has chips or scratches, this touch-up paint will fix the damaged areas. The paint is white in color and comes in a 6 fluid ounce bottle with a brush for an easy touch-up application to your appliance.
References to the manufacturer’s name, logo and or OEM part numbers are for identification purposes only. Cheap Appliance Parts © 2022