Front Load Washer Won't Fill With Water
If your washers not filling, here you will find troubleshooting help with some of the most common solutions to repair your broken front load washer with.
WARNING – If you are attempting to repair any household appliances yourself, be aware that you are working with potentially dangerous electrical currents that can cause serious bodily injury or death. Always remove the electrical power source from the appliance before you ever begin working on it. Be aware that appliances have extremely sharp edges and moving parts that can cause serious bodily injury or death. Be aware that there are many other dangers and precautions involved in appliance repair besides those listed above. We strongly suggest that you please read our DISCLAIMER before any further actions are taken or proceeding any further. Always think safety first! Note – You must turn both the hot and cold water supply valves off at the wall that lead to the back of the washer before removing any hoses or hose clamps.
Troubleshoot Why A Front Load Washer Won’t Fill With Water With These 4 – Steps
Step-1. Strainer Screens
If your washer won’t fill with water, check the water inlet valve strainer screens for blockage Reminder – you must turn both the hot and cold water valves off at the wall that lead to the back of the washing machine before doing this. Check the hose washer screens inside the ends of each hose if any are present, as well as the screens inside of the water inlet valve. If any blockage or debris is present, carefully clean the debris out with a small brush and water.
Step-2. Incoming Electrical Power
The first thing to check is to make sure that the washer is plugged into the electrical wall outlet, if it’s plugged in, you will need to look for a blown fuse or a tripped circuit breaker in your homes main circuit breaker box. If you do not have a blown fuse or a tripped circuit breaker you will need to test the electrical wall outlet with a volt meter, if you do not have a test meter, try plugging something else that runs on 110 volts into the outlet to see if the outlet is bad or good. If you do have a test meter, the wall receptacle test should check at 115V plus or minus 10 percent, if the wall receptacle is faulty, replace it.
Step-3. Water Supply
Is the water supply to the washer turned on? If you have just recently installed the clothes washer the water supply at the wall may not have been turned on.
Step-4. Water Inlet Valve
You will need to test the water inlet valve solenoids for continuity using either an analog multimeter or a digital meter. If the test shows that both of the valve solenoids do have continuity, the valve should be good. If one or both of the solenoids do not have continuity, the part is faulty and will need to be replaced with a new one. Tip – If you do not have a test meter one can be purchased fairly cheap from one of the larger hardware stores, it is a real time and money saver when your troubleshooting the various electrical components on a washing machine.
More Related Washer Symptoms
Search For Parts by Brand Name
All of the parts on this site are authentic (OEM) Original Equipment Manufacturer replacement parts, unless otherwise noted in the detailed products description.
Admiral Parts | Amana Parts | Bosh Parts | Crosley Parts | Electrolux Parts | Estate Parts | Frigidaire Parts | GE Parts | Hotpoint Parts | Inglis OEM Parts | Jenn Air Parts | Kenmore Parts | LG Parts | Maytag Parts | Roper Parts | Samsung Parts | Whirlpool Parts | Dryer Parts | Dishwasher Parts | Washer Parts | Refrigerator Parts | Oven Parts | Range Parts | Stove Parts | Appliance Parts
References to the manufacturer’s name, logo and or OEM part numbers are for identification purposes only. Cheap Appliance Parts © 2021