GE Stove Parts

View General Electric Stove Parts Category

General Electric Gas Stove Valve Pressure Regulator

Part Number – WB19K10044

This part is a safety valve used on a gas stove.  The valve is used to prevent gas from leaking until the oven igniter gets hot enough to ignite the gas.  The pressure regulator automatically cuts the flow of gas off when a certain pressure is reached.  You will need to be sure to turn the gas off and disconnect the electricity to your stove before installing this part.

GE Stove Broil Element

Part Number – WB44K10002

This broil element is located in top of the oven cavity and is used for broiling.  Quite often the broil element is used to help preheat the oven inside of an electric stove quicker.  If your broil element has stopped heating you will need to check for visual signs of damage such as, burn marks, bubbling or blistering, burnt or melted terminal ends.  Your element can be tested for continuity using a multi-meter.  You will want to be sure and use your stoves model number to ensure that this is the correct part for your specific appliance.  Safety reminder: We suggest that you wear safety gloves while troubleshooting or testing any of your stoves elements.  just because an element is not glowing red hot, doesn’t mean that it is not hot, it can still burn you long after you have shut the stove off.

GE Stove Temperature Sensor

Part Number – WB21X5301

This temperature sensor is located on the top back wall of the oven.  The sensor is used to regulate and measure the temperature in the oven.  If you have noticed your oven temperature is inaccurate or fluctuates by 50 degrees or more, the sensor is more than likely defective and should be replaced.  Be sure to use your model number to be certain that this is the correct part for your specific appliance.

General Electric Stove Temperature Control Thermostat

Part Number – WB20K8

This thermostat control is used to establish and maintain the temperature inside of the oven.  Please remember to disconnect the electrical power source to your stove before making any repair procedures to your appliance.  It is suggested that you use your model number to insure that this is the correct replacement part for your specific appliance model.

GE Stove Control Board

Part Number – WB27K10355

Gas stove electronic control board.

General Electric Stove Bake Element

Part Number – WB44K5012

This bake element is located on the bottom of the oven in some stove models.  If you have noticed that your electric stove is not heating while trying to bake, the heating element may have burned out and will need to be replaced if so.  Please remember to always disconnect your stove from its electrical source before attempting to repair it.

GE Gas Stove Glow bar Igniter

Part Number – WB13X25261

This igniter/glow bar is used in the oven compartment on some stoves to ignite the gas to flame for the broiler.

GE Stove Bake Element

Part Number – WB44X5043

This bake element uses screws to connect the terminal ends to the terminal block.  The element is mounted in the bottom of the ovens cavity and is used to bake with.   Please disconnect the electricity to the appliance before you ever begin to repair it. Safety note: Please be certain that your stove has had plenty of time to cool down before removing, troubleshooting or testing any parts.  Some stove parts can retain their heat for quite sometime and will still burn you long after you have turned your stove off.  Be safe!

General Electric Stove Igniter

Part Number – WB16K10035

This burner igniter does not come with the wire nuts.  Note: The igniter connector may need to be cut off and spliced directly to the stoves wires, using porcelain wire nuts to secure the wires with.  To ensure that this is the correct part for your particular unit, we suggest using the model number on your appliance.  Please don’t forget to disconnect the electricity to the unit before making this repair.

GE Stove Broil Element

Part Number – WB44K5009

This broil element is used in the top part of the oven compartment on some electric stove models.  The element has (2) push on spade terminals and is 240 volts.  We suggest using your model number to be sure that this is the correct part for your electric stove.  Please don’t forget to unplug or disconnect the electrical power source to the appliance before attempting to replace this element.

Appliance Category

Browse parts for major brands

Site Information

Home Page

About Us

Contact

 

Model Number Help 

Locating Your Model #

Terms & Conditions

DISCLAIMER

Shipping Information

Same Day Shipping

 

All of the parts on this site are authentic (OEM) Original Equipment Manufacturer replacement parts, unless otherwise noted in the detailed products description.

References to the manufacturer’s name, logo and or OEM part numbers are for identification purposes only.  Cheap Appliance Parts  © 2021

Top