Hotpoint Appliance Parts

Hotpoint Timer

OEM Part Number – WE4M527

The timer is located in the console panel on top of the appliance.  This is a genuine OEM timer,  the part is used to control the various timed cycles within the clothes dryer.  It uses sets of cam operated switches that direct electric current to the dryer motor and heating element at the appropriate times for the selected cycles.  Some common symptoms that this part has failed are, dryer will not run, will not heat, will not stop at the end of a cycle, will not advance through the cycle.  Please don’t forget to unplug the power cord to your appliance before attempting to repair it.

Hotpoint Defrost Thermostat

OEM Part Number – WR50X122

This defrost thermostat clips onto the evaporator and is located in the freezer section of the refrigerator.  The thermostat is used to control the temperature rise of the freezer during the defrost cycle.  Some common signs that the thermostat has failed are, the fridge temperature is warm, freezer is warm, icemaker not producing ice, freezer will not defrost.  Please be sure to use your model number to ensure that this is the correct thermostat for your appliance.

Hotpoint Detergent and Rinse Aid Dispenser

OEM Part Number – WD12X10163

OEM detergent and rinse aid dispenser.  This part is located inside the dishwasher door. The dispenser is used to hold dishwasher detergent and rinse aid and dispense them both during the wash cycles.  Some common signs that the dispenser is not working are, dishwasher not cleaning dishes, won’t dispense detergent, lid won’t latch, lid will not open.  Please be sure to use the model number to ensure that this is the correct part for your appliance.  Please remember to unplug or disconnect the electrical power source to the unit before attempting to replace this part.

Hotpoint Water Inlet Valve

OEM Part Number – WD15X10003

This water valve assembly is mounted behind the kick plate on the lower left or right corner of the appliance, depending on your model.  The inlet valve is used to supply and fill the dishwasher with water.  Symptoms of a failed water valve are, dishwasher will not fill with water, not cleaning dishes, leaking water or noisy.  To ensure that this is the correct OEM part for your specific unit, we suggest using the model number on your appliance.

Hotpoint Pump and Motor

OEM Part Number – WH23X10030

Washer drain pump and motor assembly.  Located in the right front corner, at the base of the washer.  The pump is used to help drain the water from the tub after each agitate cycle and during the spin cycle.  A common symptom that the pump has failed is, the washer will not drain the water out of the tub.   Helpful tip: Check the pump ports and the impeller for blockage or clogs before replacing the pump with a new one.

Hotpoint Temperature Sensor

OEM Part Number – WB21X5301

This temperature sensor is located on the top back wall of the oven.  The sensor is used to regulate and measure the temperature in the oven.  If you have noticed your oven temperature is inaccurate or fluctuates by 50 degrees or more, the sensor is more than likely defective and should be replaced.  Please be sure to use your model number to be certain that this is the correct OEM replacement part for your specific appliance.

Hotpoint Heating Element

OEM Part Number – WE11X20397

Heating element and housing assembly.  This part is located inside on the back of the appliance.  If your electric dryer is not heating, you will need to test the thermal fuse first.  If the thermal fuse is good, you will need to check for loose or burnt wires or a break in the heating element coils.  if the coils have a break in them, the heating element will need to be replaced with a new one.  The most common symptom of a bad heating element is the clothes dryer will not heat.  You will need to disconnect the electrical power source to your appliance before attempting to replace these parts.

Hotpoint Evaporator Fan Motor

OEM Part Number – WR60X10307

This genuine OEM evaporator fan motor comes with the wire harness and thermistor.  It is located in the back of the freezer compartment.  This part is used to move air across the hot refrigerator coils, converting the heat into cold air, which is then circulated throughout the unit.  Some common complaints associated with an evaporator fan motor that has failed are, freezer is warm, fridge is warm and noisy.  Always unplug your appliance before you begin to repair it or replace any parts.

Hotpoint Broil Element

OEM Part Number – WB44K10002

This broil element is located in top of the oven cavity and is used for broiling.  Quite often the element is used to help preheat the oven faster.  If your element has stopped heating you will need to check for visual damage such as, burn marks, bubbling or blistering, burnt or melted terminal ends.  This element can be tested for continuity with a multi-meter.  Please remember to disconnect the electrical power source to your oven before attempting to repair it or replace any parts.

Hotpoint Lid Switch

OEM Part Number – WH12X1043

This Lid switch assembly is located beneath the top part of a top load model washing machine, it is activated when the lid is opened or closed.  The assembly is held into place with two screws and has a quick connect electrical wire harness.  The most common signs that this switch has failed are, the tub will not spin, will not agitate.  Please use your model number to be sure that this is the correct OEM part for your specific appliance.

Appliance Parts

Hotpoint Dishwasher Parts

Hotpoint Dryer Parts

Hotpoint Oven Parts

Hotpoint Range Parts

Hotpoint Refrigerator Parts

Hotpoint Stove Parts

Hotpoint Washer Parts