Kenmore Range Parts

Kenmore Range Surface Burner 8″

Parts Number – WP660533

This surface coil burner is used on the cooktop surface part of some freestanding Kenmore electric ranges.  This range surface burner is 2600 watts and measures 8″ in diameter.  It has a five-turn coil with rolled terminal ends.  If your range has a surface element that is not heating, you can test the part for continuity by using an analog or digital multi-meter.  If the test shows that the element has continuity, then it is good and you will need to test the surface element switch and the element terminal to see if they are bad.

Kenmore Range Bake Element

Part Number – WPW10308477

This bake element is located inside the bottom part of the oven cavity on some Kenmore electric range models.  This is an OEM replacement bake element that has (2) flat push-on terminals.  Some common symptoms of a bad bake element are, the element will not heat, trips the circuit breakers when turned on, blows a fuse.  Please disconnect the electricity to the range before attempting to repair it.  Turn the breaker dedicated to the unit off or pull the fuses.  Safety reminder: It is recommended that you wear gloves while troubleshooting, testing, removing or replacing any parts on your range.  Just because an element is not glowing red hot, doesn’t mean that it is not hot, it can still burn you long after you have turned your range off.  You will want to give the unit plenty of time to cool down before you start to repair it.

Kenmore Range Temperature Sensor

Part Number – WPW10181986

This sensor works in conjunction with the oven main control board to regulate and measure the temperature in the oven.  If you have noticed the oven temperature in your range is inaccurate or fluctuates by 50 degrees or more, the sensor is more than likely defective and will need to be replaced.  Please be sure to use your model number when searching for parts, to be sure that it is the correct replacement part for your specific range model.

Kenmore Range Surface Element 6″

Part Number – WP660532

This surface element is used on some electric range cooktop surfaces.  The coil element measures 6″ in diameter and has rolled terminal ends.  If your range has an element that is not heating, it can be tested for continuity using a multi-meter.  If the surface element shows that it has continuity, the part is good and you will need to test the element terminal and the surface element switch.  Please don’t forget to disconnect the electricity to your appliance before attempting to remove or replace any parts.

Kenmore Range Broil Element

Part Number – W10856603

This broil element is located on the top of the oven cavity and used for broiling.  The element is often used to help preheat the oven faster for baking.  If your heating element is bad you should be able to see some kind of visual damage, such as, blistering, bubbles, burned marks, burnt or melted terminal ends.  You can test the element for continuity using an OHM meter.  Always unplug or disconnect the electrical power source to your appliance before attempting the replacement of any parts.

Kenmore Gas Range Safety Valve

Part Number – WPW10293048

This gas valve is used on some gas range models with an oven to

sense a desired amount of heat.  Once it has sensed the desired

amount of heat it will open the valve to let the gas flow to the oven

burner where it will then be ignited into flame and used to heat with.

Please unplug or disconnect the electrical power source to the range

before attempting to repair it.

Kenmore Range Thermal Fuse

Part Number – WP3196548

This thermal fuse is used as a safety device in case the oven should overheat. This fuse will shut the oven off to prevent a fire.  Please remember to unplug or disconnect the electricity to your appliance before making this repair.

Touch-up Paint – White

Part Number – 72017

This touch-up paint can be used on the exterior of your white range.  If your gas or electric range has unsightly chips or scratches, this touch-up paint will fix the damaged areas.  The paint is white in color and comes in a 6 fluid ounce bottle with a fine brush for an easy touch-up application to the exterior of your appliance.

Kenmore Gas Range Bake / Broil Igniter

Part Number – WP8054129

This part is used to ignite the ovens gas burner with it’s spark electrode.  It is the ignition device for the baking or broiler setting on your oven.  The common symptom of a bad igniter is, the burner will not light.  Please remember to disconnect your appliance from its electrical power source and turn off the gas before attempting to repair it.

Kenmore Range Surface Heating Element 6″

Part Number – WPW10345407

This heating element measures 6″ in diameter and is used on the cook top surface of some electric slide in range models.  It is a three turn coil element with rolled terminal ends that push in and pull out of the ranges element receptacles.  You will need to unplug or disconnect the electrical power source to the range before you begin to service it.  Please be sure and use the model number on your appliance to ensure that this is the correct part for your specific model.

Range Parts

Kenmore Parts