Kenmore Refrigerator Parts

Kenmore Refrigerator Condenser Fan Motor

Part Number – W10124096

This condenser fan motor replacement parts kit is used for some Kenmore side by side refrigerator models to move air across the condenser coil.  The part kit includes the motor, fan blade, screws and wire harness.  These parts have been redesigned and updated by the manufacturer and may not look the same as the original parts.  This is a genuine OEM replacement part and will function the same as the original parts.  The most common complaints that the condenser fan motor has failed are, the fridge is warm, the freezer is warm, both the freezer and fridge are warm, noisy in the freezer section.  Please use your model number to ensure that this is the correct repair part for your specific fridge.

Kenmore Refrigerator Temperature Control Thermostat

Part Number – WP2198202

This cold control thermostat is used for the refrigerator and freezer compartments as a temperature sensor.  The most common symptoms of a failed temperature control thermostat are, the fridge won’t start, runs too long, is too cold, too warm or won’t start at all.

Kenmore Refrigerator Evaporator Fan Motor

Part Number – WP2315539

This evaporator fan motor is used to circulate air over the refrigerator coils which converts heat from the coil into cold air that is then circulated throughout the refrigerator from the spinning fan.  This part is located in the back of the freezer compartment.  Some signs that this part has failed are, noisy, fridge too warm, freezer too warm, fridge and freezer too warm.  Always unplug or disconnect the electrical power source to the fridge before attempting to repair it.  Please be sure and use your model number to ensure that this is the correct part for your specific appliance model.

Kenmore Refrigerator Start Relay and Capacitor

Parts Number – W10613606

The start relay and run capacitor parts are both mounted on the side of the refrigerator compressor.  This start relay is used to help start the compressor as a jump start device.  If the start device and capacitor are not working the compressor might not start running.    Always unplug or disconnect the electrical power source to the fridge before attempting to repair it.

Kenmore Refrigerator Ice Bucket Assembly

Part Number – WPW10312300

This ice bucket assembly is used to catch and store the ice that is produced from the icemaker.  The auger inside the ice bucket is used to rotate and move the ice cubes forward to the dispenser.  The new auger may be made of either metal or plastic depending on which factory produced these OEM replacement parts.

Kenmore Refrigerator Condenser Fan Motor

Part Number – 833697

This condenser fan motor kit is used to draw air through the refrigerator condenser coils and over the compressor motor.  The most common symptoms that this part has failed are, the fridge temperature is warm, the freezer is warm, does not defrost, no ice cubes are being produced.  Please remember to always unplug or disconnect the electrical power source to your appliance before attempting to repair it.

Kenmore Refrigerator Defrost Control Circuit Board

Part Number – 4388931

This OEM adaptive defrost control board is used to determine when and how often the defrost mode should cycle.  The defrost heater and the defrost thermostat should be tested with a multi-meter before replacing this part.  If both the defrost thermostat and heater test good, the control board has more than likely failed and will need to be replaced.  Please remember to unplug the refrigerator before you ever start to repair it.

Kenmore Refrigerator Defrost Thermostat

Part Number – WP4387490

This bimetal defrost thermostat is a clip-on replacement thermostat, it is located in the freezer section of the refrigerator.  The thermostat is used to control the temperature rise in the freezer during the defrost cycle.  The most common signs that the thermostat has failed are, the fridge temperature is warm, freezer is warm, icemaker not producing ice, freezer will not defrost.

Kenmore Refrigerator Defrost Heater

Part Number – WP2323198

This heater is used to heat the evaporator during the refrigerator’s defrost cycle.  The heater is mounted at the bottom of the evaporator in the freezer compartment.  When replacing the defrost heater the thermostat should be replaced as well.  The most common symptoms that the heater has failed are, the fridge is warm, the freezer is warm, the freezer does not defrost, no ice cubes.  Please use the model number to ensure that this is the correct replacement part for your specific refrigerator model.  Remember to unplug your appliance before making this repair.

Kenmore Refrigerator Water Inlet Valve

Part Number – WP2315576

Single water inlet valve.  Used to control the flow of water into the icemaker mold, when activated.  This part is solenoid operated.   When it is energized the water in the supply line will pass through the valve body and into the ice mold.  Symptoms of a water inlet valve that has failed are, leaking water, no water to the icemaker, icemaker won’t make ice.  Always unplug or disconnect the electrical power source to the fridge before attempting to repair it.  You will also want to turn off the water source to the appliance.

Refrigerator Parts

Kenmore Parts