View Maytag Parts Category
Parts Number – 285751
Top load washer agitator parts kit. This washer replacement parts kit comes with (4) directional cogs, also known as dog ears. The parts kit also comes with the agitator cam. The main symptoms that these agitator parts have failed are, the top part of the agitator will not catch and rotate properly, the top half of the agitator should catch and ratchet in one direction when the washing machine is in the wash cycle. If you have noticed that the top part of the agitator will not agitate these genuine OEM replacement parts should repair your washer. Please be sure to enter the model number located on your washing machine when ordering this kit, to ensure that these are the correct parts for your specific appliance model.
Part Number – WP660532
This small surface burner is used on the cooktop surface of an electric range. If your surface element is not heating the part can be tested for continuity using a multi-meter. Safety note: Be mindful that some range parts can hold residual heat for quite a while after the appliance has been turned off. It is suggested wearing gloves while testing or replacing any heating elements or burner parts.
Part Number – 72017
This touch up paint can be used on the exterior of your white appliance. If you have an electric or gas appliance that has unsightly chips and scratches this touch up paint will repair the damaged areas. The paint is white in color and comes in a (6) fluid ounce bottle with a brush for an easy touch up application.
Part Number – WP2315576
This Single water inlet valve is used to control the flow of water into the icemaker mold, when activated. The valve is solenoid operated, when it is energized the water in the supply line tube will pass through the valve body and into the ice mold. Some common symptoms of a water inlet valve that has failed are, leaking water, no water to the icemaker, icemaker won’t make ice. Please remember to unplug the power cord to your appliance before you begin to repair it. You will also want to make sure and turn off the water source to your refrigerator before removing the broken valve.
Part Number – 279311
This gas dryer igniter kit comes with a bracket, (2) wire nuts and the mounting screw. The parts kit can replace both flat and round style igniters. The igniter is located inside of the burner assembly. Some common signs that the ignitor has failed are, the clothes dryer will not heat, takes to long to heat. Note: you will need to take extra precautions while handling this part, it is very fragile. Please remember to unplug the electricity to your appliance before you begin to replace this part.
Part Number – 12001656
This temperature sensor is located inside the oven compartment. The temperature sensor is used to measure and regulate the internal temperature inside of the oven cavity. This sensor is approximately 6 inches long and comes with (2) wire harness adaptors and the installation instructions.
Part Number – WP3412D024-09
This burner head is located on the surface of your gas range. It is black in color and comes with a spark electrode. You will need to rotate / turn the burner counter clock wise an eighth of a turn to remove the burner head unit from the cooktop surface. The manufacturer has updated the burner head and it no longer requires a gasket / seal. Reasons for replacing this part are: The burner will not light, it is broken or the enamel finish is cracked or worn off from extended use. Please be sure and enter your model number to be certain that this is the correct replacement part for your specific model.
Part Number – 279838
This electric dryer heating element is 240 volts 5400 watts, it is located inside the back of the clothes dryer and is attached to the heater housing. If your electric dryer is not heating, you will need to test the thermal fuse first, it is located on the blower housing, if the thermal fuse is good then you will need to check for loose or burnt wires or a broken heating element coils. If the coils have a break in them, the whole heating element will need to be replaced with a new one. Please disconnect the electrical power source to the appliance before attempting to repair it. Be sure and enter the model number to be certain that this is the correct part for your particular model.
Part Number – WPW10312300
Ice bucket with auger. This ice bucket / container is used to catch and store ice in the freezer that is produced from the icemaker. The auger inside of the ice bucket is used to rotate and move the ice cubes forward to the ice dispenser. The new auger may be made of either metal or plastic depending on which factory produced these parts.
Part Number – WP7432P143-60
This bake/broil igniter is used to ignite the gas to the oven burner. If your gas oven will not turn on or has little to no heat this part will need to be visually inspected or tested and should be replaced, if it is broken. Note: Please be sure to match this connector with the old part. Please remember to disconnect the electrical power source and turn the gas off to the range before you start this repair. It is recommended that you enter your model number to make sure this is the correct part for your specific unit.
Search by your Appliance Type
Browse parts for major brands
References to the manufacturer’s name, logo and or OEM part numbers are for identification purposes only. Cheap Appliance Parts © 2021