Whirlpool Refrigerator Parts
View Whirlpool Refrigerator Parts Category
Part Number – WP2315539
The evaporator fan motor is used to circulate air over the refrigerator coils which converts heat from the coil into cold air that is then circulated throughout the refrigerator from the spinning fan. This part is located in the back of the freezer compartment. Some signs that this part has failed are, noisy, fridge too warm, freezer too warm, fridge and freezer too warm. Always unplug or disconnect the electrical power source to the refrigerator before attempting to repair it. Please be sure and use your model number to ensure that this is the correct part for your particular appliance.
Part Number – WP2198202
This cold control thermostat is used for the refrigerator and freezer compartments as a temperature sensor. The most common symptoms of a failed temperature control thermostat are, the fridge won’t start, runs too long, is too cold, too warm or won’t start at all.
Part Number – W10613606
The start relay and the run capacitor are both mounted on the side of the refrigerator compressor. The start relay is used to help start the compressor as a jump start device. If the start device and capacitor are not working the compressor might not start running. Always unplug or disconnect the electrical power source to the fridge before attempting to replace these parts.
Part Number – W10124096
This condenser fan motor kit is used for some refrigerators to move air across the condenser coil. This kit included the motor, fan blade, screws and wire harness. These parts have been redesigned and updated by the manufacturer and may not look the same as the original parts. This is a genuine OEM replacement parts kit and will function the same as the original parts. The most common complaints that the condenser fan motor has failed are, the fridge is warm, the freezer is warm, both the freezer and fridge are warm, noisy in the freezer section.
Part Number – WPW10312300
Refrigerator ice container with auger. This ice bucket is used to catch and store the ice that is produced from the ice maker. The auger inside the ice container is used to rotate and move the ice cubes forward to the dispenser. The new auger may be made of either metal or plastic depending on which factory produced these OEM parts.
Part Number – 833697
This condenser fan motor kit is used to draw air through the refrigerator condenser coils and over the compressor motor. The most common symptoms that this part has failed are, the fridge temperature is warm, the freezer is warm, does not defrost, no ice cubes being produced. Always unplug or disconnect the electrical power source to the appliance before attempting to repair it.
Part Number – WP2323198
The heater is used to heat the evaporator during the defrost cycle. The heater is mounted at the bottom of the evaporator. When replacing the defrost heater the thermostat should be replaced as well. The most common symptoms that the heater has failed are, the fridge is warm, the freezer is warm, the freezer does not defrost, no ice cubes.
Part Number – WP4387490
This bimetal defrost thermostat is a clip on thermostat, it is located in the freezer section of the refrigerator. The thermostat is used to control the temperature rise in the freezer during the defrost cycle. The most common signs that the thermostat has failed are, the fridge temperature is warm, freezer is warm, icemaker not producing ice, freezer will not defrost.
Part Number – 4388931
This adaptive defrost control part is used to determine when and how often the defrost mode should cycle. The defrost heater and the defrost thermostat should be tested with a multi-meter before replacing this part. If both the defrost thermostat and heater test good, the control board has more than likely failed and will need to be replaced. Unplug the fridge before attempting to replace this part.
Part Number – WP2315576
Single water inlet valve. Used to control the flow of water into the icemaker mold, when activated. This part is solenoid operated. When it is energized the water in the supply line will pass through the valve body and into the ice mold. Symptoms of a water inlet valve that has failed are, leaking water, no water to the icemaker, icemaker won’t make ice. Always unplug or disconnect the electrical power source to the refrigerator before attempting to repair it. You will also want to turn off the water source to the appliance.
Browse parts for major brands
All of the parts on this site are authentic (OEM) Original Equipment Manufacturer replacement parts, unless otherwise noted in the detailed products description.
References to the manufacturer’s name, logo and or OEM part numbers are for identification purposes only. Cheap Appliance Parts © 2021